triadahook.blogg.se - N1mm logger digital change

N1mm logger digital change manual#

The assumption is made that the SO2R Box is working correctly on CW before you attempt to set it up for RTTY.

Note: Both FSK control lines require the use of a keying interface to operate FSK RTTY. Send a message on Radio 1, and the audio in both headphones should be that of Radio 2.

Now select “Latch” on the SO2R Box Interface.

The audio in the headphones should change from mono (Rx focus radio in both ears) to stereo (Radio 1 audio left ear, Radio 2 audio right ear).

Make sure that “normal” is the audio selection on the SO2R Box Interface.

The red LEDs on the front of the SO2R Box should change in step with the Pause key. N1MM Rx and Tx focus should change from one Entry Window to the other.

The CW speed in the Entry Window with the Tx focus should vary. Put both Switches on the SO2R Box in the center or “Auto” position.Open the 2nd Entry Window (use backslash “\”).COM Port for SO2R in SO2R Interface: COM 18.COM Port for SO2R in N1MM Logger: COM 8.COM Port for Keyer in SO2R Box Interface: COM 17.COM Port for Keyer in N1MM Logger: COM 7.In my case, the setup in N1MM Logger and the SO2R Interface are as follows: The “Two Radio Protocol” should be changed to “OTSRP”, the “Radio Number should be “BOTH”, and RTS should be set to PTT. Find the COM port that is in the pair that you have set up for the SO2R Control in Step 2 (in my case, COM 8).DTR, RTS, Foot Switch, and CW/PTT Port Address are all irrelevant. Make sure the “Radio number” is “BOTH”, and that the “SO2R Box Protocol” is None. Then click on “set” for that COM port and put a check mark for “Winkey”. Find the COM port that is in the pair that you setup for the keyer in Step 2 (in my case, COM 7).If you had a different SO2R Box Controller setup, TURN IT OFF.Find the port or method you are currently using to generate PTT.Find the port that is currently being used to generate CW.Configure both radios and check the SO2R tab.Open up the N1MM Logger Config and choose “Configure Ports, Telnet Address, Other”.Click the “Logger controls keyer”, click the :”Keyer PTT”, make the Radio Boxes specify Radio 1 and Radio 2, select the correct COM port specified in the drop down box for the Keyer box and check “keyer” select the Com port for the SO2R and then check “SO2R” In my setup, Keyer is checked and the Com port is COM 17, and SO2R is checked and the Com port is COM 18.If you try to start N1MM Logger first, the program will show you the “About N1MM Logger” screen and sit there forever, so you must start this first. Make note of which COM ports you are going to use for the keyer and SO2R Control.

N1mm logger digital change manual#

See the SO2R Box Manual for more information it is a little tricky to set these up. Set up two virtual port pairs using com0com or n8vbcomm in my setup, I paired COM 7 with COM 17 and COM 8 with COM 18. Versions: N1MM Logger 9.12.9, SO2R Box Interface, MMTTY 1.66Gīefore attempting to use the SO2R Box with N1MM Logger, you should verify that it is working correctly with the SO2R Box Utility. Configuring N1MM Logger for the YCCC SO2R Box